This long spline kit is designed to replace the stock slip section and nearly doubles the useable slip length. To install this kit the stock slip section and tubing is cut off and replaced with our long spline section and new tubing.
Our drive shaft kits are also stronger then stock. Our testing shows that a stock drive shaft will twist off and fail at after a maximum load of 3,900 ft/lbs of torque is applied. Our shaft kits test to a maximum of 4800 ft/lbs or torque. This is accomplished in two ways; first we increase the size of the material both on the inside and outside of the slider section. Then we specially heat-treat the material to increase its strength.
Each kit comes with a Heavy Duty U-joint installed. Full circle retaining rings are installed to securely hold the u-joint in place.
Note; this product is a heavy duty replacement part and is not recommended for applications requiring a balanced driveshaft. Not recommended for use on the street or speeds over 50mph. This driveline can not be balanced.
Click for full product info